- Will a stud finder work through aluminum?
- How far apart are the studs in a travel trailer?
- How far apart are metal studs?
- Can I mount a TV on metal studs?
- How thin can a stud wall be?
- Can you nail into aluminum siding?
- How do you find studs under siding?
- Do stud finders work through metal?
- How do I know if I have aluminum studs?
- How do you find a stud in metal siding?
Will a stud finder work through aluminum?
they are attracted to magnetic steel or iron- If metal siding is thin aluminum or another non ferrous metal and nailed with magnetic or ferrous nails it should work.
Also the latest versions of these stud finders only have 2 magnets in them, if drywall or si… see more.
These work on very basic principle..
How far apart are the studs in a travel trailer?
It’s worth noting that studs inside a camper are usually spaced irregularly, and sometimes up to 24″ to 36″ apart. They’re not like those found in a residential house, on 16″ centers. There may be sections of plywood added in between the studs to reinforce certain areas in your RV’s walls.
How far apart are metal studs?
24 inchesJust like wood framing, metal studs should be spaced 16 or 24 inches apart. This allows for the installation of wallboard and other wall sheet products that come in standard sizes. After installing the floor and ceiling tracks, each metal stud is measured, and the length is cut to fit.
Can I mount a TV on metal studs?
Metal studs are hollow and narrow, so you’ll need hardware that will be strong enough to support the weight of the television and long enough to reach the studs. … Snap toggles are stronger than a toggle bolt or drill toggle and can be used as an anchor for installing a flat screen TV through metal, drywall, and plaster.
How thin can a stud wall be?
Thinnest Possible Wall The thinnest workable wall of standard timber frame construction is 1.5×2. 5 framing, fitted the thin way, with 12mm plasterboard. Noise reduction meaures are generally necessary, as such walls conduct sound well otherwise.
Can you nail into aluminum siding?
Nails for Vinyl or Aluminum Siding Vinyl and aluminum siding can be fastened with hammer and nails or by using a power nailer or stapler. For more about the latter, see Power-Nailing & Stapling Vinyl Siding. For vinyl siding, use aluminum, galvanized steel, or other corrosion-resistant nails.
How do you find studs under siding?
Use a good quality stud finder or rap firmly on the wall and listen for a solid sound, indicating a stud is beneath. You can also check base molding or crown molding for filled nail holes, which indicate stud location. Another clue is the location of outlets and switch boxes because one side should connect to a stud.
Do stud finders work through metal?
All stud finders can detect wood, most detect metal, and many also detect live electrical wiring. Some finders provide basic detection capabilities that are good for just walls. Others can be used on floors and ceilings.
How do I know if I have aluminum studs?
use a magnetic or electronic stud finder. These are fairly cheap (about $10 – $20) and can be used to find both wooden and metal studs. go outside in the early morning (when there’s dew on the exterior of your camper) and you should notice an outline of the studs.
How do you find a stud in metal siding?
Remove the cover plate. If you have gaps around the outlet box, use a long nail or knife blade to locate the stud on either side of the box. The box is attached to a stud on one side. If there are no gaps, use a long thin nail and nail it about 1/2″ from the edge of the box on each side into the wall.